How To Install Barn Door Sliding Hardware
How To Install Barn Door Sliding Hardware – A sliding barn door in the house is a unique and stylish way to provide privacy. Use these step by step to install hardware for barn door sliding instructions. Make sure you have the necessary hardware. The hardware system barn door sliding should include the following: track flat steel track joint brackets, spacers, screws, bolts, carriage bolts, suspension rollers, bottom roller guide and lower rollers.
To ensure of track to the wall and add support for heavy barn door sliding hardware, cut a board mounting plates of the same length but slightly wider than the track. Use drywall anchors, spacers and bolts for fixing the mounting plate. Cutting track with the required length twice the width of the door allows the door to open up the entire width of the room door.
Then measure and drill holes with a metal cutting steel track of barn door sliding hardware where it attaches to the mounting plate and the wall. Use an awl or pick ice to make seats for the drill so it will not slip on the metal while it is drilling. Apply some cutting oil drilling in the hole to keep cool area. Place the suspension rollers to the door according to the manufacturer’s instructions using the supplied bolts carriage, washers and nuts. Use a socket wrench to tighten. With another person or two, place the guide rollers and lower rollers, and hang the door on the track.