Rubbermaid storage cabinet shelving system is a wire rack cabinet using a horizontal rail to hold the posts in place. Wire racks; click down on the mounting brackets. The horizontal rail is the only part of the platform that needs to be fixed to the wall. You can use these systems in the dressing closet, linen closet, pantry, garage and bathroom. Shelves come in white, but you can spray paint if you want another color.
Mark the spot on the wall where you want to install the horizontal mounting Rubbermaid storage cabinet. It must be 2 higher than the desired height of the shelf inches. Use a stud finder to locate the studs at the height you want to install the mounting rail. Mark with a pencil asparagus with a level as a straight edge so that all brands are even. Keep the mounting rail to adjust their brands and so many screw holes are on the uprights as possible. Secure the mounting rail in your screwing the screws through the holes with an electric drill and a screwdriver instead.
12 Photos Gallery of: Installing Rubbermaid Storage Cabinet
Click the uprights on the mounting rail by reducing the notch on the end of the upright on the lip on the mounting rail. Hold the first support from the shelf at an angle of 45 degrees with the rear left upright. Slide the notches back into holes that are straight to the desired height of the platform. Push the stand down until it clicks into place and leveled horizontally. Repeat with the second carrier in the vertical position to the right, using the holes at the same height. Place the wire rack on top of the bracket so that the wiring front to back is parallel to the support. Push down on the shelf on the bracket, and again on the wall until the rear lip of the shelf snaps into the notch on the back of the stand Rubbermaid storage cabinet.